Description: This ebay Buy-It-Now offering provides (1) pair of PT850-13 engagement dogs each per B-I-N price. These are new OEM paired parts come without factory sealed packaging as shown above. These dogs will fit all Snap on models: IM5100, IM6100, IM6500, XT7100 and MG725 as well as the PT850. The hammer pins and frames for each tool above should be used as paired exactly to their tool model number. These new dogs should be used a new mated pairs for correct tool performance. PT850-13 OEM dogs each weigh 120 grams or 4.2 ounces each. My ebay store listed items are in stock. I do not take ebay orders and drop ship them a week later from another source. ebay competitors who copy my listings and attempt to compete with me typically do not stock their items and take longer to ship the products they sell here. *One symptom that engagement dogs or hammers are worn out is that the while tool builds rpm (so internal binding and worn vanes are not an issue) and hits solidly on the fastener it will take a fair amount of trigger pull time to loosen or tighten the bolt or nut. An anvil used with worn dogs takes on excessive wear or chipping either on the internal contact points to the dogs or on the square drive by starting to round the 4 drive end corners. Check to make sure that you have 90 PSI to the tool with full trigger depression and that the inlet screen is not plugged, that the tool air fitting is a high volume air flow type and that your air hose is not internally fragmenting causing air delivery problems to the tool. Amflo CP7 style or Morse equivalent is my standard fitting recommendation. Snap on only sells new anvils for the MG725 or XT7100 sold as MG725-12-13 (an anvil paired with new dogs for about $160). Always change engagement dogs in pairs and make sure the anvil is deburred on any slightly chipped contact points with the dogs. If you are not sure change the anvil and the dogs together or risk shattering the hammer frame with excessive and prolonged hammering. Installation (see above photo details) for: IM5100, IM6100, IM6500, XT7100 and MG725: *Make sure the inside recessed area (one per each hammer or dog) faces each other (side) recessed dog. Recesses must face each other to the inside while locating the single hammer pin slot (outside perimeter) forward and the wider hammer pin groove (outside perimeter) toward the rear hammer frame splines. This is noteworthy since the older Snap on anvils will only work with these correctly positioned dogs.AGAIN: *Make sure to rotate the dogs and align them so that the single hammer pin slot (on the outside perimeter) faces toward the front of the tool.*Make sure to rotate and align the wider hammer pin slot (on the outside perimeter) toward the rear splines.*This positioning counterbalances the motion of the hammer frame assembly inside the tool. The shipping weight is 12 ounces with an ebay USPS Ground Advantage shipping label and tracking. International orders ship to Glendale Heights, Illinois where the eBay Global Shipping Program takes over to finish the documentation and final delivery.
Price: 42 USD
Location: Sparks, Nevada
End Time: 2023-12-11T20:24:01.000Z
Shipping Cost: 0 USD
Product Images
Item Specifics
Returns Accepted: ReturnsNotAccepted
Brand: Snap-on
Non-Domestic Product: No
Type: Air Tool Parts
Warranty: No
Custom Bundle: Yes
Manufacturer Part Number: PT850-13
Country/Region of Manufacture: United States
Modified Item: No
California Prop 65 Warning: N/A
