Headlight Replacement Lamps For 03-07 Honda Accord Black Housing Amber Corner

Description: --> Compatible With: Fit for 2003 2004 2005 2006 2007 Honda Accord Coupe/Sedan Features: Completely sealed: Prevents moisture from being trapped inside the housingOne-way vent: Drives out moisture and avoids lens mistingMulti-surface reflectors: Increase light output & distance PC lens: Impact resistance for an enhanced driving experience in any environment. Specifications: Condition: 100% Brand New and High QualityMaterial: Plastic Housing / Polycarbonate LensColor: Black Housing + Clear Lens+Amber ReflectorHigh Beam Bulb: 9005/HB3 (Bulbs are NOT included) Low Beam Bulb: 9006/HB4 (Bulbs are NOT included) Turn Signal Light: 1157A (Bulbs are NOT included) Side Marker Light: 1157A (Bulbs are NOT included) ls that meet or exceed OEM requirements Easy installation, direct bolt-on, no modifications Package Includes: Pair of LH(Driver Side) & RH(Passenger Side) Headlight Headlamp Installation Guide: WARM TIPS (How to install your headlight): 1. Undo the screws, clips, or retainer springs that hold the headlight in place. 2. Disconnect the wiring from the assembly. 3. Detach the headlight from the vehicle to replace it with a new one. 4. Fit in the new headlight assembly. 5. Fix the new headlight into place and make sure that the screws, clips, or retainer springs used are sealed. 6. Reconnect the wiring that was unplugged from the assembly. 7. Put back the grille and other components that you removed. Seal them back into place. 8. Test the new assembly. WARM TIPS (How to adjust your headlight): Before you begin to adjust the light, make sure to check the alignment of your lights first. Park the vehicle about 10 to 25 feet from the wall with the lights aimed at the wall. The centerlines of the headlights should not be any higher than 3.5 feet above the ground. 1. Find the adjustment screws. Firstly, locate the adjustment screws on your vehicle. 2. Adjust the headlight individually. Adjust the headlights individually. The headlights should be adjusted one at a time. Put a rag or towel over a chair in front of the light you want to block. Covering the light assembly directly can damage the plastic lens. 3. Adjust the vertical field. The screw on the top of the light housing should be turned clockwise to raise the lights and counterclockwise will lower the light. The headlight should be adjusted until the top of the most intense part of the light beam shines directly on or just below the center of the tape line on the wall. 4. Adjust the horizontal field. The screw on the side of the light housing should be turned to get the right/left adjustment correct. Adjust the lens so that the most intense part of the beam is to the right of the vertical line. 5. Test your results. Condensation DOES NOT Mean a Product Problem It's normal that the condensation appears inside the headlights because of temperature differences, air pressure, etc, thus it is not the quality problem of headlights. How to Remove Temporary Condensation 1. Check the vents to prevent blocking and switch on the low beam light for about 20 mins 2. Take the headlight bulb out and drive out moisture 3. Put a silica gel packet in the housing to soak up moisture WE ACCEPT THESE PAYMENT METHODS ( 10% sales tax will be applied for orders shipped to Washington state by state law ) 30 Days easy returns satisfaction guarantee. Items to be returned must be in original factory condition. Please enclose a note about item number and order id, your eBay ID and the reason of return. On Jul 9, 2023 at 22:35:28 PDT, seller added the following information:

Price: 69.99 USD

Location: Atlanta, Georgia

End Time: 2023-11-13T09:59:18.000Z

Shipping Cost: 0 USD