Description: Autel PowerScan Automotive Circuit Tester, Power Circuit Probe Kit, Digital Multimeter/Relay & Diode Resistance Tool, for Frequency/Duty Cycle/Voltage Test, Activating Component, w/ 20ft Cable About this item đ„ă2024 ALL-IN-ONE POWER CIRCUIT TESTER KIT---ACCURATELYăAutel PowerScan Circuit Tester is most accurate power circuit probe tester yet, with 160x128 TFT display test all 6-30 volt vehicle electrical systems. It supports voltage&polarity test, continuity test, signal circuit test, components activate, check bad grounding, locate short circuits, circuit breaker protection, etc. Intuitive interface with ergonomic design makes it be best gift for all novice drivers or pro circuit repairers. đ„ăFOUR WORKING MODE---INTUITIVE&EASYăFour working modes make circuit detection more simple:DC Voltage, AC Voltage, Resistance, Tone On/ Off. DC Voltage mode can read DC voltage with 0.1V resolution; AC Voltage can read Max & Min voltage, frequency and duty cycle quickly; Resistance mode can read resistance between tip and auxiliary ground wire. Unique Tone On/Off Design is really useful when working in bright areas, it can judge the circuit voltage according to the volume of the sound. đ„ăCOMPONENT ACTIVATIONăThe component activation feature is specially designed to troubleshoot on/off-board electrical equipment. By activating the signal generated by the component, you can accurately judged whether the component is intact, such as blower motor, power window motor, windshield wiper, rear window defroster, lights, radiator fans, fuel injectors, etc. Autel circuit tester automotive tool can activate component in your hand/ in the vehicle/ with ground etc. đ„ăINSTANT IDENTIFY POLARITYăAutel Automotive Circuit Tester instantly checks component continuity and quick identifies positive, negative and open circuits. When the positive terminal is connected, red LED lights up with beep sounds. When the negative terminal is connected, green LED light up with a low tone. If an open circuit, neither of LED light will not light. The indicator light is a considerate working guide to facilitate the smooth operation of detection. đ„ăCONTINUITY TEST, SIGNAL CIRCUIT TESTăAutel Electrical System Tester can test the state of sensors, quickly and accurately judge the connectivity of circuit via transmitted signal, performing continuity test. Two ways to test continuity: â 1: In resistance mode, if the resistance is 0.0Ω and the LED lights up, it means continuity. â 2: Power up the connection using the power switch, if the circuit brea-ker tr-ips, that means the resistance is low and there is continuity. đ„ăOVERLOAD PROTECTION, QUICK SELF-TESTăThis Electrical System Probe Tester has a built-in short circuit protection. When overloaded, built-in internal short circuit will automatically trip to ensure the safety of users and prolong the service life of the tester. In order to protect your components, the car circuit tester can also perform a quick self-test. After flipping the switch forward or backward, the LED light and tone will respond to quickly check its actual operating status. đ„ă20FT EXTENSION CABLE, BUILT-IN FLASHLIGHTăAutel PowerScan circuit tester comes with extra 20ft extension cable in addition to its own 20ft cable, allowing you to access any position of the vehicle and test it. Ideal for trailer wiring, it can be tested along the vehicle without having to find a suitable ground point. The built-in flashlight is convenient for detection, even in the dark or dim environment, it can provide the best view for who need to work in night. đ„ă1-YEAR WARRANTY, PERFECT SERVICEăAutel Car circuit tester provides 1-year warranty, and supports 30 days no reason to return. Autel Direct store has been engaging in Autel brand for 9 years, aiming to offer top-ranking products with best service. If you have any problem with product quality or have any other issues, you can contact us asap. Product Description Autel PowerScan 100 Circuit Tester Kit--- Do Everything For You DC voltage range : 0-65V +1 digit; Resistance range : 0–200 KΩ; Frequency response of tone passage: 0Hz to 10Khz. Performs multi-service including power injection, measurement, ground testing, polarity checks, continuity testing and components activation Easy to read AVOmeter allows you to read voltage, current and resistance at the fingertip Component activation with a flip of the power switch, Instantly identifies positive, negative and open circuits Test bad ground contacts instantly, allowing you to follow and locate shorts fast without wasting fuses Instantly checks continuity of switches, relays and diodes Circuit breaker protected Extra 20ft (extendable) cable provides excellent accessibility to test along the vehicle Built-in Flashlight, work in the dark Simple button design More Useful Features, Give You Try Autel PowerScan 100 has rich functions, please check the following introduction: 4 modes to diagnose the electrical system: DC voltage, AC voltage, resistance, diode. Voltage & Polarity Test: According to the LED light and sound after the probe tip touches the circuit, it can accurately judge the positive, negative, and open circuits. Continuity Test: While the tool is in Resistance mode, using the probe tip with chassis ground or the auxiliary ground lead, continuity can be tested on wires and components attached or disconnected from the vehicle’s electrical system. Signal Circuit Test: When the vehicle has a fault code, in order to quickly determine whether the fault is caused by a certain sensor circuit, you can use this tool to quickly draw a conclusion. Find Short Circuit: A short can manifest itself as a blown fuse or a tripped electrical protection device. Use the probe tip to activate and energize each fuse contact. The contacts that trip the circuit breaker are shorted. Find Bad Ground: Probe for suspected ground wires or touch probe tips. If the breaker has tripped, the circuit is most likely grounded. Activate Component in your hand/ in the vehicle/ W/Ground Test Trailer Lights and Connections: Check function and orientation of connectors and trailer lights Red/Green Polarity Indicator: The red/green polarity LED illuminates when the probe tip voltage matches and is within ±0.8 volts of the battery voltage. It is additional information that may be of value to a technician. DC Voltage While the tool in this mode, contact the probe tip to a circuit, then the LCD display will read the DC voltage with a resolution of 0.1 volt. AC Voltage While the tool in this mode, contact the probe tip to a circuit, then the LCD display will read the Max. voltage, the Min. voltage, frequency and duty cycle. Resistance While the tool in this mode, contact the probe tip to a circuit, then the LCD display will read the resistance between the tip and auxiliary ground lead. Tone On/ Off While the tool in this mode, just do a quick press of the mode button to toggle the tone on or off. While quickly pressing (a quick press and release) the mode button, if a short high beep is heard, this means the audio tone is turned on. If a short low beep is heard, the audio tone is turned off. 20ft Extension Cable 20ft Extension Cable: Autel PowerScan 100 itself has an extra-long 20ft cable, considering the volume of 12V-24v vehicles such as ships and trucks, we have additionally equipped with extra 20FT extension cable for emergencies. With the 20FT extension cable, you can freely test the condition of any vehicle circuit without moving the device because the cable is not long enough. Autel PowerScan 100 Circuit Tester has two power supply methods: 1. Vehicle battery power supply 2. Ciga-rette li-ghter power supply Quick Self-Test: Before you test a circuit or component, be sure your tool is in good order by doing a quick self-test. With the tool connected, perform a quick self-test. The power switch is a momentary rocker switch located on the tool's body. Flanking the switch are positive and negative markings. Press the Power Switch forward to activate the tip with a positive voltage. The Red LED should light and the LCD display will read the battery voltage. If the tone feature is turned on, a high pitched tone will sound. Let go of the power switch and the LED will turn off and the high tone will cease. Press the Power Switch rearward to activate the tip with a negative voltage. The Green LED should light and the LCD display will read the „0.0Vâ (ground). If the tone feature is turned on, a low pitched tone will sound. Let go of the power switch and the LED will turn off and the low tone will cease. Your tool is working correctly and is now ready for use. DC voltage range 0-65V +1 digit Resistance range 0 – 200 KΩ Frequency response of tone 0Hz to 10Khz Circuit Breaker Rating current 1 – 10 Amp External Power 12.0 or 24.0 V power provided via vehicle battery Display TFT color display (160 x 128 dpi) Package Including 1* PowerScan P-S-100 1* 20ft. extension cable 1* Rugged blow molded case 1*Probe tip 1* Battery clips 1*Ciga-rette lig-hter adapter 1*User's Manual On Jul 18, 2024 at 23:22:49 PDT, seller added the following information:
Price: 85 USD
Location: Perth Amboy, New Jersey
End Time: 2024-08-09T15:49:49.000Z
Shipping Cost: 0 USD
Product Images
Item Specifics
Restocking Fee: No
Return shipping will be paid by: Seller
Returns Accepted: Returns Accepted
Item must be returned within: 30 Days
Volt: 6- to 30-volt vehicle electrical systems
Modified Item: No
Country/Region of Manufacture: China
Custom Bundle: No
Features: Digital Display, Relay & Component Testing, Continuity Testing, AVOmeter, test light, built-in flashlight, short circuit indicator, bad ground indicator, power injection, measurement, ground testing, polarity checks, components activation, Circuit breaker protected, Audio tone indicator, VOLTAGE & POLARITY TESTING, SIGNAL CIRCUIT TESTING, TESTING TRAILER LIGHTS AND CONNECTIONS, ACTIVATING COMPONENTS IN THE VEHICLE, ACTIVATING COMPONENTS W/GROUND, FOLLOWING & LOCATING SHORT CIRCUITS, DUTY CYCLE, LONG CABLE, Voltmeter, Red/Green Polarity LED
Manufacturer Part Number: KZYEE KM10 KM50 PB100
Vehicle Type: Passenger Vehicle, Heavy Duty/Commercial
Accessories: Carrying Case, Probes, User Guide
Brand: Autel
Non-Domestic Product: No
Warranty: 1 Year
Display: TFT color display (160 x 128 dpi)
Operating Temperature: 0 to 60°C (32 to 140°F)
External Power: 12.0 or 24.0 V power provided via vehicle battery
Length\Width\Height: 126mm(4.96â)\46.5mm(1.83â)\35mm(1.38â)
NW: 0.105kg (0.23lb),GW: 0.726 kg(1.6lb)
Model: Autel PowerScan PS100
similarmodels: PT101 BT705 BST500 Power Probe 3 III Circuit Tester
Storage Temperature: -40 to 70°C (-40 to 185 F°)
Dimensions: 126 mm (4.96â)x46.5 mm (1.83â)x35 mm (1.38â)
DC voltage range: 0-65V +1 digit
Resistance range: 0 â 200 KΩ
Frequency response of tone pass through: 0Hz to 10Khz
Circuit Breaker Rating current: 1 â 10 Amp
About Diode Testing: poor ground contact instantly W/O performing voltage drop test
