1858 Remington, Pietta, Howell Made Conversion Cylinder .44

Description: This stainless conversion cylinder converts stainless steel Pietta 1858 Remington revolvers from .44 black powder to .45LC/.45Schofield smokeless ammunition. Reloading/loading is done by removing the cylinder and then removing the cylinder cap from the cylinder. The cylinder contains 6 firing pins retained by threaded doughnuts. The cap is reinstalled by lining up the hole in the cap with the silver guide pin on top of the cylinder. If shooting black powder ammunition the firings pins must be removed and cleaned to avoid corrosion. No frame modification is needed, although minor fitting may be required due to gun manufacturer variations. Do not exceed 250 grn or 850fps. .45 LC converter for the Pietta stainless 1858 *WILL NOT FIT Uberti. Non gated converterStainless steelFor Use with,.45LC6 Shot (.45LC)Steel Frame Guns OnlyLow Velocity Ammo (Max rating for ammo is 850 fps 250gr)If you need something you can't find here just message me. Drew ~ TWSSH NOTE: May require special fitting by a gunsmith. Sometimes they will fit right out of the box but because the revolvers over the different years may vary, they may not always fit correctly out of the box. This is for Pietta models only 1858 Remington converters. These Converters are to be Used on Steel Frame Guns Only. No Brass Frames for These Calibers.These are machined parts. There are no returns here with this eBay sale. In the event of a poor fit you can either have a local gunsmith match to your gun or I will give you contact info of where to send both pieces to have them matched. Max rating for ammo is 850 fps 250grAll packages insured and shipped Priority Special deals for repeat customers that come direct. If you have any questions please message me here.Thank you for stopping by...Drew~TWSSH

Price: 350 USD

Location: Lincolnton, North Carolina

End Time: 2024-11-27T20:54:09.000Z

Shipping Cost: 15 USD